Dot Sights

The best red dot is the one that fits your firearm: match your slide cut or rifle rail, choose the right dot size, and get an optic built to hold its zero.

Laser beams vanish in direct sun, while reflex red dots stay visible on target. Balance lighting, speed, and recoil to lock in your ideal aiming setup.

Green dots pop in bright daylight and stay clearer if your eyes blur, while red dots run much longer on one battery. Balance your vision, backdrop, and power.

Tap out the tight Ruger 10/22 front sight from left to right using a brass punch and padded vise. Seat your new sight cleanly without scratching the barrel.

Swap your peep sight at home without nicking bowstring strands. Mark your height, balance the fibers, and tie it tight so it aligns straight at full draw.

Clear the broken rod, slide in the right size, and mushroom the ends with gentle heat so your glowing sight holds tight under recoil without burning the metal.

Knock out the taper pins from the smaller side, remove the front sight tower without gouging the barrel, and add a low-profile gas block so your rifle cycles.

Drive the taper pins out from left to right, free the gas tube, and slide the fixed sight tower off your rifle barrel cleanly without damaging the steel.

Hit what you aim at without a sight pin. Lock your draw hand to the same spot on your face every time and use the arrow tip to line up a repeatable shot.

Line up your bead using the receiver as a rear sight, lock your cheek to the stock, and pick an open choke to keep lead slugs on target at 50 yards.

Focus on the front sight post, keep it level in the rear notch, and let the target blur. Steady your cheek against the stock for clean, centered rifle hits.

Stop hunting for the dot inside the glass. Keep both eyes open, focus on the target, and push the sight straight up so the dot appears where you look.

Most pin lights take stacked LR41 or LR44 button cells, while digital bow sights use a CR2032. Match your housing size and decode store battery codes easily.

Brush away loose grit first, then gently lift smudges and powder soot with safe fluid. Keep your red dot glass clear without stripping coatings or losing zero.

Center the outer ring in your peep, keep the bubble level, and read pins from closest at the top to farthest below so you stop missing high, low, or wide.

Straighten a peep sight that turns sideways at full draw. Clear your sight picture by adjusting the D-loop, sliding in a tuner, or adding a bowstring twist.

A 0.014 to 0.020-inch serving thread works best for a peep sight, with 0.015 being ideal. Lock your sight tight so it never slips or cuts into string strands.

A 0.019-inch pin fits most archers best. Switch to 0.010 for precise shots past 40 yards, or use 0.029 to keep your aiming dot visible in thick, dim woods.

A 3/16-inch peep sight is standard for hunting, while 1/4-inch adds light at dusk. Frame your front sight ring cleanly so you never lose game in low light.

Choose a dedicated 6.5 Creedmoor cartridge laser or a .264 muzzle adapter. See why .308 tools jam and zero your new sight without wasting expensive ammo.