Move your rear sight in the direction you want hits to go. Turn click screws or push dovetailed sights safely without gouging the slide or wasting ammo.
Lower your front sight post to raise bullet impact, or move it toward your misses. Turn, press, and zero rifle or pistol sights without wasting ammo.
Move your rear sight where you want shots to hit and your front sight the opposite way. Follow these simple steps to center your hits without wasting ammo.
Move your pins toward the miss to center every shot. Set the main housing at 20 yards, adjust left and right safely, and fine-tune each individual pin.
Follow your arrow to zero your Apex bow sight. Loosen the lock screws first, then move the pins or housing left, right, up, and down to hit dead center.
Zero your entire sight housing at 20 yards before moving single pins. Loosen lock screws properly to protect adjustment gears and dial in your yardage tape.
Zero your 20-yard pin first, then center the alignment dot to your natural anchor. Here is how to adjust your pins and stop hand torque from pulling shots.
Zero your pin at 20 yards, mark the dial at 40 or 60, and pick the right yardage tape without moving your sight the wrong way or running out of travel.
Always chase your arrow by moving the sight toward your miss. Set your 20-yard pin first with the whole housing, then dial in individual pins step by step.
Fix peep rotation by twisting your D-loop or using a string spacer, and nudge peep height safely at home without prying strands or risking string damage.
Stop straining your neck at full draw. Check your natural anchor point, safely slide your peep sight up or down the bowstring, and tie it securely in place.
Straighten a crooked peep sight at full draw by nudging your D-loop, adding a string spacer, or putting half a twist in the bowstring with a press.
Fix a twisted peep sight and set the right height for your natural anchor point. Straighten your sight picture safely without nicking bowstring strands.
Sighting in a 223 dot sight at 50 yards keeps hits within two inches out to 200 yards. Save ammo and avoid the high misses of a 25-yard setup.
Sight in at 100 yards for a scope or 50 yards for a red dot. Choose the best target distance for your setup to stop missing high or low and save ammo.
Zeroing at 15 yards balances close-range height-over-bore offset with flat trajectory to 25 yards. Align your defensive slide optic without wasting live ammo.
Zero your pistol at 15 to 25 yards and rifles at 36 or 50 yards to keep trajectories flat, eliminate confusing holdovers, and stop wasting range ammunition.
Rifle recoil shakes weak diodes off target. Equip your AR-15 with a shockproof red laser sight featuring secure rail clamps that hold zero shot after shot.
Avoid optics that shift under recoil or sit too low. Match your AR-15 with the proper riser height for a clean cheek weld, motion activation, and a solid zero.
Match your handgun slide to the right optic footprint, avoid loose adapter plates, and pick a red dot sight that holds zero through heavy slide recoil.
